Can I change auto version?

[Spice It Up]

I will try this again, I am going round and round with jigsaw 6.3, trying to find some way to get it to work from all the wonderful help people tried to give me. However, I am desperate, so was wondering if I can try switch my 6.3 version to 6.0. I tried that version with the trial and liked it but when this one came out I tried this and it worked fine until I bought it then I can't get it to work for anything. So i want to see if 6.0 would be better for me. :( Is this a good idea to do, and can I even do it? Thanks for any help and answers.

[Scarlette]

Version 6.3 has now been released. This will work on Medium difficulty only. Before sending a problem report, please make sure you have tried the "slow" speed setting first. When the puzzle is solving, the only way to stop the auto is to press and hold the [ESC] key for a few seconds.... Email Joe with questions, comments and concerns. Hold down the left shift key to enable insane speed mode

There is one known bug .. sometimes it takes 4-5 tries before it stacks the border properly. If that happens, let it go through it's cycles. Once it completes that puzzle, it usually goes just fine from then on. Again, IF IT IS SKIPPING PIECES OR GETTING STUCK, change your speed first to medium and then try it.

Spice, this is what I took off of the BadgeHelp website for Jigsaw 6.3.  Have you tried everything it said to do on the website?  I wish you could get it to work and maybe a Admins will help you get 6.0 back.  Good Luck and if you need any help you know where I am at. ;)