is not a valid Win32 application solution

[no fear]

I recently joined the 150 club after being very impressed with certain bots on badgehelp and one of the bots I downloaded gave me an error telling me it is not a valid Win32 application.

After searching these forums i found a few posts with people having similar problems. One of the solutions on the posts was to delete the bot reboot and then re-install the bot, I tried this and no luck, and then it suddenly hit me.

When you downloaded the bot if you clicked "run" instead of "save" then the bot would be located in the temporary internet folder which isn't very easy to access manually.

So here are the steps you should take if you are having the same problem

If you clicked "save"
1) Delete the bot from the directory you saved it to.
2) Then reboot your computer and download the bot from badgehelp again and it should work perfectly

If you clicked "run"
1) Go to my computer
2) Right click on the c: drive
3) Go to options
4) Then click "disk clean up"
5) Your computer will then search for files to clean up
5) Then from the list given to you make sure you check the box next to "temporary internet flies"
6) Click ok and wait until all these files are cleaned up (this may take a while)
7) Then reboot your computer and download the bot from badgehelp again and it should work perfectly

(If you clicked both "save" and "run" then follow both procedures before rebooting your computer)

I hope this helps people with the same problem.

no fear